Brakes are a safety critical part of your motorcycle, ineffective brakes can and will cause DEATH or SERIOUS INJURY. Do not attempt to service or install brakes unless you are qualified and even then follow manufacturers guidelines and the EBC INSTALLATION VIDEO available on line on our website which shows how to install brakes, how to detect worn rotors and pads and how to change them.

Worn discs or rotors dramatically extend bed in time and will reduce brake effect severely until pads bedded in. Ride SLOWLY AND CAREFULLY after installing new brakes until you are satisfied brakes are performing to your total satisfaction.

Please note ….There is NO WARRANTY on any EBC product used in Racing.

To bed in brakes with new rotors, undertake this in a practice session and allow 20 medium speed "snubs" at 10 second intervals scrubbing off speed from 90 MPH to 60 MPH followed by 10 snubs taking speed from 110 MPH to 60 MPH again with 10 second intervals. This will avoid rotor pick up. If rotors are pre -conditioned against sintered pads and perfectly flat, bed in time for PADS ONLY can normally be achieved within two warm up laps with 7-10 snubs from 110 MPH to 60 MPH. Bed in time depends on rotor condition, allow longer bed in for even slightest dishing of rotors. If you have previously used carbon based pads you MUST Scratchpad or sand rotors lightly to remove carbon coating.

Is 10-12 slowdowns in clean dry conditions on discs in an undished and unscored condition, worn or grooved discs/rotors extend bed in time dramatically.