As you know if you are a motorcycle driver, your brakes are some of the most important parts on your bike. It is a top priority to keep the motorcycle brake components as clean and fresh as possible. So when it comes time to replacing the motorcycle brake fluid and pads where do you turn? Why not do them yourself? Yes, it may seem as if you are not capable of doing a motorcycle brake change yourself, but reading these easy instructions carefully and even having someone help you can save you a few bucks in the long run. Remember only to attempt brake changes if you feel able to perform them correctly and safely, if not, approach a qualified professional mechanic.

There are many different brake pad systems to choose from now a days. They have versions which say they last longer than the original and others say they make it seem that the bike brake has more power if you use their product. Either way, if it is time to change the motorcycle brake pads do it as soon as possible to make sure you are safe along with others on the road.

Head to your local motorcycle shop or look online and see which brakes they suggest for your make and model of the bike.

Once you have the correct pads and are ready to install, remove the calipers from the rotor and check the general state of the brake components. If in doubt about the condition of your brakes, contact a mechanic. If you are certain that it is indeed the brake pads which have worn down proceed with the directions below.

Removing the two bolts on the caliper in the front will free the brakes off the disc for the motorcycle brake replacement to begin. Remove the pin which holds one side of the brake on before trying to remove the brake pads off the disc and caliper. Do the same with the back motorcycle brake system as you did with the front.

Once the old motorcycle brake pads are removed it is time to replace them with the new. Make sure the new brake pads are secure in the caliper and mounted properly. Once this is done it is now time to bleed the lines.

Replacing the brake fluid on your motorcycles should be done at least every two years to keep everything running smoothly. You will need a wrench, brake bleeding kit, brake fluid overflow container for excess which spills out, rags for the mess you may make, and of course brake fluid.

The beginning process of bleeding the brakes is to attach the bleeding kit onto the brake caliper. Loosen the valve to release the old fluid to drain into the container. Remove the cylinder cap and add new brake fluid. Pump the brakes to force the fluid through the tubes. Keep pumping the brakes until the fluid comes out clear. Remove the kit, replace the cap on the cylinder top and you are set to enjoy a cruise. Before embarking on any journeys, make sure that you are confident that all parts are fitted correctly and are fully functional.